The ruckus' oil filter is useless at filtering metallic flakes. A magnetic drain plug does a great job at picking up metallic flakes in your oil, protecting your engine.
A 10-pack of drain plug sealing washers. Replace your sealing washer at every oil change to prevent an oil leak.
A new spark plug can breathe new life into the ruckus' highly sophisticated motor. A worn out plug can affect engine performance and top speed.
7.48mm diameter - Includes three valve shims of each size from 1.20 to 3.50mm in .05mm increments. 141 shims in total. 57 cents per shim! Does your local dealer have the shims you need?
The higher pressure in the radiator raises the coolant boiling point and increases protection from coolant loss due to overheating.
23 PSI - 1.6 Bar.
- No more dead batteries. Holds charge for one year without maintenance
- Two to four times the life of lead-acid batteries
- Carbon Fiber Composite Case
- Faster cranking for better starts
- Environmentally friendly, just discharge and dispose
- Ultra light and compact - you could easily carry a spare
- Each Shorai battery includes self-adhesive foam panels to achieve a snug fit in your battery box
Shorai recommends the LFX14-L2 for this application.
- LFX14-L2 measures 4.5" x 2.25" x 3.5", weighs 1.68 lb and is rated at 210 cranking amps
- For reference the stock YTZ10S weighs 7 lb and is rated at 190 cranking amps
This black motorcycle license plate frame includes six white full-spectrum HID type LED bulbs on a 6-inch strip for bright illumination of your license plate. The LED motorcycle license plate frame is made with a sturdy cast aluminum and powder coated in a black finish that won't easily come off or get scratched. You can see the six LED's in the upper edge of the frame in the image above.
Outside frame dimensions are 7.25 in. wide by 4.2 in. tall for a license plate that is 7.1 in. x 4.1 in. The center to center mounting hole distance is 5.7 in. All mounting hardware is included.
Ultra bright amber LED turnsignals offer nearly the same visibility in a much smaller package. 15 amber LEDs in every signal. Flexible rubber stalks. Requires a LED turn signal flasher to flash properly.
These bright LED turn signals will bend more than 90 degrees without damage. Only 2 1/2" long. Requires a LED turn signal flasher to flash properly.
Optimate 1 Global Charger-Maintainer
This charger is perfect for 24 hour, 7 days a week, 365 days a year smart battery maintenance. It delivers precise microprocessor controlled charging and long term maintenance. Maintain any type of 12 volt lead-acid filler cap / wet cell, sealed AGM (MF) or GEL battery without overcharging. Ideal for vehicles that are seldom or seasonally used, or in storage. Global Three-step charging program ensures effective charging of the battery and is totally safe for prolonged connection to the battery, without risk of overcharging. Automatic shut-down if short-circuited or battery disconnected. Dust proof case with wall mounts, with 6ft AC supply lead and 6 ft. charge lead ending in SAE connector. Velcro strap slot to hang the charger on handlebar. Weatherproof battery lead & OptiMate battery clip set included.
Optimate 2 Maintainer
OptiMate 2 senses the battery condition, recharges and then keeps the battery 100% ready. The OptiMate maintenance program delivers only what the battery needs, never overcharges, never undercharges. Provides power to the on board computer, display or antitheft alarm. Totally safe for vehicle electronics. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected. Works with standard filler caps, and sealed maintenance-free units. Includes permanent ringlet connector with weatherproof cap and battery clips. Comes with global input (100-240V).
Optimate 3 Optimizer
Recovers sulphated batteries and then tests after charging. The maintenance program delivers only what the battery needs, never overcharges, never undercharges. Provides power to the on board computer, display or antitheft alarm. Diagnoses, recovers, charges, tests and optimally maintains, automatically. Comes with global input (100-240V). For batteries forgotten over the winter, OptiMate 3 will recover them from deep discharge and optimally recharge them. Batteries status can be checked at a glance. OptiMate 3 will then maintain the battery at full charge safely for months at a time and increase life by up to 400%. Works with standard AGM, and gel batteries. Do not use with Lithium batteries.
OptiMate™ lithium, the first OptiMate to protect your LiFePO4 battery unlike any other charger. Will protect your investment and keep your Lithium Iron Phosphate (LiFePO4/LFP) battery performing as advertised for a very long time. With 5 Amps of charge current available, OptiMate lithium's unique multi-step ampmatic™ program recharges and balances cells within the battery quickly and efficiently. Optimate lithium's maintenance program delivers current to the vehicle circuitry, protecting and keeping the battery at 100% charge. Tests and displays battery condition before charging. Voltage retention test is conducted for 30 minutes during which no charge current is delivered, and provides results indicating the battery's general state of health. The 12-hour MAINTENANCE CHARGE CYCLE consists of 30-minute float charge periods at a voltage of 13.6V followed by and alternating with a 30-minute "rest" (no charge current) periods. Includes permanent ringlet connector with weatherproof cap and a set of battery clips.
You can charge your Shorai battery with a regular battery charger but if you want the very best for it, this charger is designed for optimum performance by balancing the individual cells in the battery. Balanced charging ensures the battery reaches its fullest capacity and longest life. 'Store' mode allows long term long term maintenance storage.
Shorai Charge/Store Dedicated Battery Management System for Shorai LFX only. 2A Max charge rate, connects via BMS 5-pin port on LFX batteries. Includes modes for full charge, or long-term storage. Input USA 110~120V 50/60 Hz.
For Shorai Lithium Iron batteries only!
All the components you need to install aftermarket LED turnsignals on your ruckus. Allows you to use the stock turn signal indicator.
The installation kit includes:
- LED flasher unit
- Wire extensions for the front signals when mounted in the stock location
- Diode kit to allow the stock turn signal indicator to work with LED signals
- Shrink tubing for the front turn signal wires
- Assortment of wire terminals to ease installation with no soldering required
Required to use LED type turn signals.
Matte black 118mm x 85mm mirrors. Similar to stock size.
• 8mm thread
Beautifully polished mirrors with billet shaft. Swivel ball-joint adjustment. No plastic parts! Includes 8mm mounting kit.
• 8mm thread
Simple, clean looking matte black mirrors have an extra long stem. Great visibility for taller riders.
• 8mm thread
Stainless steel head pipe and silencer.
The Mini Powercore 4 features a Hi-Flo stainless steel core and formed end caps, an aircraft grade aluminum canister and a durable stainless steel header. Its pounds lighter than stock.
This Full System features a stainless steel head-pipe and a mini TRC muffler, with stainless steel or carbon fiber sleeve and end cap.
Tired of paying too much for OEM paper filters? Drive in wet/rainy weather? Get an K&N filter for your ruckus! K&N filters are reusable, waterproof, and will save you money over the life of your scooter.
- Fits in the stock air box with no modifications needed.
- One filter will last the lifetime of your scooter with proper maintenance
- Increased air flow over the stock air filter
- Four layers of premium cotton gauze provides outstanding filtration
- Washable & re-usable, never wears out
- K&N filters are waterproof. Perfect for wet weather riding where a stock paper filter would get destroyed.
Replaces the stock 2 wire Ruckus fuel level unit with a 3 wire unit that allows use of a multi-level fuel gauge. Special Order, allow 1 week lead time.
Premium drive belts offer longer life than standard ones. A worn drive belt can affect your scooter's top speed.
- Current Speed
- Maximum Speed
- Selectable MPH/KPH Display
- Real-Time RPM Bar Graph
- Numeric RPM Readout
- Dual Programmable Shift Lights
- Up to 20,000 RPM
- Ambient Temperature
- Engine Temperature (sensor included)
- Dual Programmable Temp Lights
- Clock, Hour Meter, Stop Watch, Ride Time, Accumulated Ride Time
- Adjustable Distance, Permanent Odometer, Selectable Mile/Kilometer Display
- Includes power connection, accepts any power input - AC/DC, auto switch to internal power if external is removed, permanent memory guarantees data is never lost
Click here to read a 'Ride Review' on the Vapor
What better way to enjoy your morning coffee or afternoon tea than in a custom ProCycle Ruckus mug. Every time you see it, you'll remember all those great rides the two of you have shared. Maybe that will get you to start planning your next ride!
Available in White
The Mini-Morph is actually a bicycle pump, but is probably the best compact pump we have found for adventure / dual-sport riding. It has a fold-out foot and handle as well as a 4 inch hose so you can set it on the ground to pump. At only 10" long, it is small enough to pack anywhere.
The Phillips type screws used in Japanese motorcycles are actually Japanese Industrial Standard (JIS) screws are very easy to strip if you are using a regular Phillips screwdriver.
Here is a little kit that will make removing and replacing JIS screws much easier. A small portable handle with its own collection of 4 various bits, along with 2 each JIS No. 1, No. 2 and No. 3 bits. These will work in any other bit holders you may have and have a slight magnetic end to hold a screw while you start it.
- Optional plastic dashboard with indicator lights protects the computer and places it in an optimum viewing position.
- Includes an assortment of indicator lights that can be customized to fit your needs.
- Does not include the Stealth Vapor (black) shown in the dashboard.
Small and compact enough to fit in your pocket, jacket or on our belt loop, HelmetLok is designed to lock your helmet to any bike using the handlebar or frame as an anchor point.
Don’t be weighed down carrying your helmet around anymore! Just use the simple to operate, carabiner-style HelmetLok and you can secure your helmet using the convenient outward opening mechanism. The combination can be reset to the number of your choice. Enjoy the security and freedom of HelmetLok.
Quick release buckles, sewn-in rain hood, removable rigid panels, and extended zipper pulls. Made from 1680-D nylon. Measures 16" x 8" x 10". Perfectly sized to fit on the sides of the stock ruckus seat frame.
Fits perfectly under the stock seat. Made from 1000-denier Cordura. Cordura is water-resistant and dries quickly. Mounts to seat frame with 4 hook & loop velcro straps. Includes a shoulder strap for easy carrying.
Windscreen attaches to your bike's handlebars. Fully adjustable mounting brackets. Includes 7/8' handlebar clamps. 14" tall 10" wide.