TTR125: Fuel and Intake

Tune your stock carburetor for better power and response, easier starting and quicker warm up. Mikuni main and pilot jets.

• Main Jets: #110 & #112.5
• Pilot Jets: #17.5 & #20

Rebuild your crusty carburetor with parts from the same manufacturer the OEM companies use. Included in the kit are all necessary gaskets, O-rings, float valve and jets you need to rebuild your carburetor to like new condition.

Genuine Keihin spring, washer, and oring for the fuel screw of FCR and FCR MX carbs.

Just the parts…
Fuel screw spring, washer, o-ring (fuel screw not included)

High-performance, high-flow filter element and filter base for the TT-R 125.

• Replaces stock filter and base
• Filter base is made from HDPE plastic
• 3 times larger than stock filter!
• Adds almost 1/2 horsepower
• Designed to fit inside the factory air box

• Bonded, two-layer foam designed for maximum protection and airflow
• Super Seal material seals off 100% water and remains air tight without grease.

Sold in 6 packs

• Compatible with many air filter boxes.  Easy to install by drilling 1’’ holes in airbox housing and snap fitting vents in.
• May be cleaned and re-oiled
• More air flow allows you to add more fuel to your intake mixture, increasing performance.
• 1" Diameter

*Not legal for use on pollution controlled vehicles in the state of California.*

Quick release one-piece clamps that saves space. These are great for fuel lines, controlling wires, and can be used many times.

Comes with 4 each of 8mm, 9mm 10mm, and 12mm.

No special tools needed, from Helix Racing.