Same-day shipping cutoff: Noon Pacific Time

Spring time is in full swing here at ProCycle.  With these busy days please be sure to let us know if your order is time sensitive.  We try to do as much as we can to accommodate your upcoming trip.  

CRF250L Rally: Fuel and Intake

CRF250L Rally

2017 - 2020 Year range.

The CRF250 Rally is a lightweight adventure bike offered from Honda.  The Honda CRF250 Rally is powered by a liquid cooled single cylinder 249cc four stroke engine mated to a 6-speed transmission. The CRF250 Rally weighs 346lbs and has a ground clearance of 10.6 inches with a seat height of 35.2 inches. The fuel tank has a capacity of 2.64 gallons.

Chain Size:        Front Sprocket:        Rear Sprocket:        Front Tire:        Rear Tire:        Spark Plug:
520x106 14T 40T 3.00-21 120/80-18 SIMR8A9

 

Fuel and Intake

CRF250L Rally '17 - '20

The EJK evolved out of the need to address the ever-increasing complexity of factory fuel injection. For the newcomer to the market or professionals wanting an easier method for tuning fuel injection, the EJK is a customizable solution for the rider that wants to take control of their tuning needs.

This unit is a piggy-back EFI controller because it does not replace the stock ECU, but rather monitors the signals to the injectors and makes fuel adjustments based on the mode settings. The GEN 3 has a push button interface allowing access up to 6 different modes to allow for quick fine tuning by the end user without needing a computer.

Key Features:

  • No computer or dyno needed!
  • Plug and play, simple to install, base settings preset
  • Unique load based technology
  • Full range tunability available
  • Does NOT interfere with stock ECU operation
  • Simple push button adjustment interface
  • Water-resistant 
  • 2-Year warranty
  • Compact size - 2.2" H x 3.4" W x 0.5" D
Please contact us for availability information
$236.95
Universal fit. May require additional adjustment or modification.

Genuine Keihin spring, washer, and oring for the fuel screw of FCR and FCR MX carbs.

Just the parts…
Fuel screw spring, washer, o-ring (fuel screw not included)

Ships in 3-5 business days
$8.95

Driven engine block off plates will stop the annoying and possibly damaging backfires from occurring while allowing you to remove a few pounds in associated valves and hoses from your bike. On late model EFI bikes with 02 sensors, ESPECIALLY when using Dynojet's Power Commander V with the Autotune feature, the air injection system MUST be blocked as it will introduce additional oxygen into the system which will skew your 02 sensor's values and make it impossible to get a correct tune.

Please contact us for availability information
$46.95
Universal fit. May require additional adjustment or modification.

Sold in 6 packs

  • Compatible with many air filter boxes. Easy to install by drilling 1’’ holes in airbox housing and snap fitting vents in.
  • May be cleaned and re-oiled
  • More air flow allows you to add more fuel to your intake mixture, increasing performance.
  • 1" Diameter

Not legal for use on pollution controlled vehicles in the state of California.

Ships same business day
$14.95
Universal fit. May require additional adjustment or modification.

Quick release one-piece clamps that saves space. These are great for fuel lines, controlling wires, and can be used many times.

Comes with 4 each of 8mm, 9mm 10mm, and 12mm.

No special tools needed, from Helix Racing.

Ships in 1-2 business days
$9.95