KLX230: Fuel and Intake

The Power Commander 6 fuel injection tuning device allows you to optimize your fuel and timing curve (where applicable) giving you the confidence to roam freely. With fine tune adjustability and multiple inputs, the Power Commander 6 will keep your vehicle running at its full potential letting you concentrate on the journey ahead.

Featuring a plug-and-play setup, Power Commander 6 can be installed discreetly underneath your seat, cowl, dash or other location ensuring your ride looks as good as it runs. Removing the device reverts your vehicle completely back to stock. With the ability to store and switch between two maps on-the-fly  (via the map switch accessory) and connect to various Power Commander accessories such as the Autotune, Quickshifter or POD-300, the Power Commander 6 gives you features and functions that provide you with the ultimate ride.

All PC6 models have an end-user adjustment of +/-15 in the FUEL table and +/- 8 in the timing table (if applicable). This adjustment is on top of the values that are in the BASE map loaded to the device. This BASE map can be any of the available maps from the Dynojet website.

• Compact design for discrete placement & easy uninstallation to revert to stock settings
• Easily change & upgrade tunes as you upgrade parts
• Comes with Power Core software that connects dyno runs with our EFI Tuning Devices to unlock your ride’s potential
• Pair with other Power Commander accessories like the Autotune, Quickshifter or POD-300
• Analog input allows you to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature
• Easily connects to your computer via USB
• Each cylinder can be mapped individually and for each gear, giving riders more granular control
• One year warranty
• Proudly made in the USA

Genuine Keihin spring, washer, and oring for the fuel screw of FCR and FCR MX carbs.

Just the parts…
Fuel screw spring, washer, o-ring (fuel screw not included)

The small size and right angle hose barbs make this filter easier to fit into the small space between your fuel petcock and carburetor. Filter body is only 7/8" diameter. Straight filter is 2" long, 90 degree filter is only 1-5/8" long.

This filter is meant for 5/16" fuel lines. Only 1/2" thick it is small enough to fit just about anywhere.

No Toil air filter to replace the stock unit. Fits the stock airbox using the standard guide and frame. It requires foam filter oil to properly trap dirt particles. Don't forget the Evolution Air Filter Oil kit from No Toil.

Here's a UNI dual layer foam air filter element for the KLX230. Needs to be treated with air filter oil like any other foam filter.

Sold in 6 packs

• Compatible with many air filter boxes. Easy to install by drilling 1’’ holes in airbox housing and snap fitting vents in.
• May be cleaned and re-oiled
• More air flow allows you to add more fuel to your intake mixture, increasing performance.
• 1" Diameter

Not legal for use on pollution controlled vehicles in the state of California.