Galfer Pad Maintenance

When installing new Galfer brake pads, be sure to clean around the pistons of the caliper according to your service manual. This helps the pistons slide easier and gives you better release for the brake pads.
They recommend cleaning the caliper pad slide pins if equipped. This will help the pads retract when the lever is released.
Most systems will not reuse the OEM brake pad shims or heat plates. Your choice.
Always check your brake fluid level in your reservoir. New pads and rotors are thicker than the old ones and too much fluid in the system can apply the brake when you are not on the lever.
Brake pads should be bedded in to clean rotors (see rotor maintenance). Start with slow stops ranging from 10-15 mph and increasing in blocks of 10 mph until about 40-50 mph. Repeat this step 2-3 times and resume casual riding. Bedding in brake pads helps prevent glazing and helps to mate the pads to the rotor surface.
Changes to the brake system are known to affect the suspension of your vehicle. You may need to adjust the settings of your suspension after upgrading your brake system.
If you are also installing brake lines with your pads and rotors, they recommend that you do the brake lines first in case brake fluid is spilled on any of the components. Brake pads can absorb brake fluid and will contaminate them.