Fuel and Intake

• These bands are the visible part of two fiber reinforced nylon injection moldings which form the structure on which the unique Tri-Foam filter system is bonded.
• The two outer layers of foam provide optimum filtration and load-up capacity while the inner layer is made of special self extinguishing filter foam.
• Together, they give the best combination for air flow, engine protection and safety.

This is ONLY a replacement filter for the ProCycle ITG kit and is not a direct swap for OEM.

This is the more economical alternative to eliminating the 990 Adventure airbox. Better breathing equals more power. The ITG filter kit makes air filter service a snap. It also simplifies other engine and intake maintenance chores. Our kit features a steel base plate which will not deform like plastic and does not conduct heat as much as aluminum. The white powder coating also helps reflect engine heat. To take advantage of the increased airflow, we recommend upgrading your fuel injection map with TuneEcu or a Power Commander.

• OPTION - Twin Air Breather Filter (replaces standard breather filter)

Genuine KTM replacement air filter. Replace your air filter at recommended service intervals.

Unsurpassed in airflow, dirt stopping and overall performance. Adding a pre-filter to your intake system gives you extra protection from damaging contaminants.

Don't have a dyno tuning center nearby? Are you more of a do it yourself type? Are you constantly changing parts on your bike?

If you answer "yes" to any or all of the questions above, then our Auto Tune kit is for you. The Dynojet Auto Tune kit is an "add on" accessory that can be used with any of the Power Commander Vs

It connects to the PCV with a single cable and requires only a ground and +12 volt connection to be made to install. If your exhaust does not already have one, a "weld in" O2 sensor bung is included

Once installed, the Auto Tune kit monitors the fuel mixture (by installing the included Wide Band O2 sensor in the exhaust). It then sends this information to the Power Commander V and automatically corrects it while you ride. Each map that we offer has preset Air/Fuel ratio values included that we find to be the best overall settings. This lets you simply plug in the unit and let it do the work.

The New Power Commander V is loaded with tons of new features.

• USB powered from computer (9 volt adapter is no longer needed for programming)
• Gear input (allows for map adjustment based on gear and speed)
• Analog input (allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature)
• With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables).
• 10 throttle position columns (up from 9 on PCIIIusb)
• Enhanced "accel pump" utility (increased adjustment and sensitivity ranges)

The map selection switch allows the rider to switch between two different maps "on the fly" within the Power Commander V.