Rear Fender comes with built in tabs designed to be used with Maier USA Side Panels.
Replacement front fender by Maier that will fit great on your TW200.
Note: The proper way to install this front is to install the stock fender bracket to the under side of new Maier front fender using stock screws and nuts.
Don't like the low fender on your TW200? The ProCycle High Mount Fender Bracket allows you to mount your fender under the lower triple clamp to create more clearance around your front wheel and drastically improve the look of your T-Dub.
The kit is made of high-quality steel components manufactured in the USA, and includes the bracket and all required hardware.
| 4 | 8x40 Bolt |
| 4 | 6x20 Bolt |
| 6 | 6x16 Washer |
| 4 | 6mm Nyloc Nut |
| 2 | Spacer |
Don't forget to add a new fender for that supermoto look!
The SignalMinder unit is designed as a plug-in accessory for many Japanese bikes. SignalMinder uses a microprocessor to cancel the turn signals at one of three selectable time outs; 10, 20 or 30 seconds.
You can also make it so that all four of your signal lights also act as running lights and establish a dual-channel system on your bike. With the dual-channel system, when you activate the RIGHT turn signal three times in succession, you get 4-way hazard flash lights.
Connecting the 12 volt supply from the brakes to the SignalMinder, also allows for a brake flash option.
There are many options and configurations using this electronic tool.
No wire cutting required. The kit includes Scotchlok connectors to tap into existing wires.
Getting ready to adjust your valves? Here is a set of feeler gauges to make the job a little easier. One tool has .002" & .003" gauges the other has .004" & .005" gauges. Yamaha lists the specs as follows: .002"-.004" Intake and .004"-.006" Exhaust, clearance measured when engine is cold.
Adjusting your valves or setting your cam chain tension? Here are the O-Rings that fit in the TDC sight plug and the crankshaft nut access plug.
