Search Products

Designed for use with stock engines using either stock or aftermarket exhaust and air filters.

• Provides a simple and affordable solution to carburetor tuning problems.
• Allows you to tune your bike for increased power and smoothness while retaining fuel economy.
• Includes a guide booklet on how to install and use your jet kit to it's full potential.
• For a top quality installation we recommend adding an extended fuel screw and a set of replacement carburetor screws.

This kit includes 2 needles that have been developed by JD Jetting and manufactured for them to their exacting specifications. These two needles allow a wide range of tuning possibilities and provide correct fuel delivery at any throttle position.

4 Allen type screws for the float bowl are also enclosed should you strip out the stock screws during your tuning process. Complete instructions with photos, jetting suggestions for different set-ups and situations, 4 Main Jets, a new Pilot Jet, and a drill bit complete the package.

The jet kit for riders who want their bike to run well but do not want to modify the air box.

The Ti ProKit w/Titanium needle adds more power and better throttle response. Easy to install and tune - no slide drilling. No air box modification.

Includes: a main jet selection, adjustable titanium needle, clips (with extras), pilot jet, instructions.

Our own jet kit for the Mikuni TM40 carburetor.

Includes new main jets, pilot jets and a new needle with e-clip.

Comes with a printed Mikuni tuning manual and a jetting suggestion chart.

  Not for the stock carburetor Fits TM40 conversions Only

Our own jet kit for the DR650 stock Mikuni BST40 carburetor. Includes the extended fuel mixture screw and stainless steel Allen screws for the float bowl and top cap. Also included are new Viton o-rings for the float. Comes with easy to understand detailed instructions and diagrams. Includes a template for modifying the air box.

Kit includes:

• 155 Main Jet
• 40 pilot jet
• #35 leak jet
• EMP needle

Not for the stock carburetor Fits FCR-MX conversions Only.

Raises compression from stock 9.5:1 to 10.5:1 for more power, torque and snappier engine response. The high quality forged piston from JE is almost a full ounce lighter than the stock cast piston. This makes for less vibration and a smoother running motor. Includes rings, pin, clips, and top end gasket set with valve stem seals and metal base gasket. Fits the standard size stock bore.