Many suppliers are experiencing HUGE increases in demand and supply chain delays.  We appreciate your patience. The quickest way to get your item is to place your order now which guarantees your place in line.

Tool Tube Installation Instructions

Submitted by Lora B on Fri, 03/15/2019 - 14:06
WR250RX Tool Tube Installation Instructions

 WR250RX Tool Tube Installation Notes

(See available PDF for printable version)

Parts Supplied




6mm x 20mm Bolt


8mm x 16mm Bolt


6mm Nylock Nut


6mm x 12mm Washer




Tool Tube Clamp


Tool Tube Mounting Bracket


3” x 13.25” Black ABS Pipe


Tube Plug


Installation Instructions

We highly recommend that you thread lock all bolts prior to installation. Periodically re-check all nuts and bolts to maintain rigidity and structural integrity.

  1. Remove the stock tool holder on the left side of the motorcycle.
  2. Remove the Helmet Lock.
  3. Mount the Tool Tube Mounting Bracket to the lower mount used for the stock tool tube as shown below. Use the 6x20mm bolt, 6x12mm washer and 6mm nylock nut provided in the kit.
  4. Remove the wing nut and the metal washer from the lower cap bolt and then place the spacer on the bolt (be sure the plastic washer is between the cap and spacer). Place the bolt through the bracket, place the metal washer and wing nut on the bolt. Just start the wing nut with a few turns, do not tighten yet. See image below for exact order of hardware. Sometimes the Plug manufacturer does not include the Plastic Washer, it is not necessary. 



  1. Place the PVC tube over the lower cap and tighten the wing nut.
  2. Slide the supplied clamp over the PVC tube and place the 8x16mm bolt through the bracket and into the threaded bracket on the frame that held the helmet lock and tighten.
  3. Place your tools in your new tube and insert end cap.
  4. Congratulations! You now have the biggest Tool Tube available for your WR.