Use this installation tool from Cogent to be sure that your Cogent Drop-in Dynamic Cartridges are installed correctly. A strong magnet in the end holds the cartridge firmly while you lower it into your fork leg. Then slide the spring over the tool until it holds the DDC down, then gently remove the tool. That simple. Never again question if it is properly seated on the damper rod.
Works equally well for removal when you need to change your fork oil. Also works great with Race Tech Emulators.
Sub-Category
Model
Fork Cartridge Dampers, Suspension
Fork Seals & Bushings, Suspension
Innovative design makes tool easier and more secure to use than old fashioned pin-aligned drivers
- Knurled anodized aluminum locking ring
- Perfectly weighted to drive seals
- Carbon steel body halves
Innovative design makes tool easier and more secure to use than old fashioned pin-aligned drivers
- Knurled anodized aluminum locking ring
- Perfectly weighted to drive seals
- Carbon steel body halves
Innovative design makes tool easier and more secure to use than old fashioned pin-aligned drivers
- Knurled anodized aluminum locking ring
- Perfectly weighted to drive seals
- Carbon steel body halves
Innovative design makes tool easier and more secure to use than old fashioned pin-aligned drivers
- Knurled anodized aluminum locking ring
- Perfectly weighted to drive seals
- Carbon steel body halves
- Extracts dirt and debris trapped between fork seal and tube
- Easy way to keep fork seals clean and debris free
- Works on conventional and upside-down forks
Forks, Suspension
Keeps the damper rod from turning so you can remove the bottom fork bolt. Perfect when replacing fork seals or installing cartridge emulators. It's a good addition to any tool box as it will fit many other bikes.
Shock, Suspension
Showa removed the schrader valve on many newer rear shocks. Now you need a needle to recharge your shock with nitrogen after a rebuild. Race Tech built this unit just for that job.
The features of this tool include 300 psi capacity, bleeder valve and T-handle plunger pin chuck. Swivel chuck has a 12" flexible hose. Comes complete with instructions, carrying box and Schrader valve extension (required on some Showa shocks). Nitrogen bottles available at any welding supply house.